Friedrich QuietMaster SS08 Manual Del Usuario página 12

Figure 1A TYPICAL MOUNTING SCHEME
10 - 4 SCREW
10 - 4 FLAT NUT
SUPPLY AIR
RETURN AIR
Figure 3A TYPICAL MOUNTING SCHEME
STONE LEDGE
STEP 9 CUT WINGBOARD PANELS – Measure and cut the wingboard
panels from the Masonite supplied (Item #8) to fit the spaces be-
tween the side window channels and the sides of the cabinet. (See
Figure E).
NOTE:
AFTER CUTTING THE PANELS, MAKE A TRIAL TEST TO SEE IF
THEY FIT THE SPACE WITH ABOUT
GOING TO STEP 10.
STEP 10 ASSEMBLE THE CLIPS TO THE WINGBOARD PANELS-
Assemble the "J" type speed nuts (Item 9) and spring steel clips
(Item 10) to the edges of the cut wingboard panels (See Figure F).
1
⅜" SLOPE
DOWN
CONDENSER
AIR OUTLET
CONDENSER
AIR INLETS
#1A x " SHEET METAL
SCREW
1" x 4" OR " x 4" SPACER
BETWEEN WALL AND
BRACKET SHOULD BE
USED ON ALUMINUM,
ASBESTOS OR VINYL
SIDING.
⅜" SLOPE
DOWN
#1 x " SHEET
METAL SCREW
" x 4" SPACER
⁄ " CLEARANCE BEFORE
1
8
920-198-00
Figure 2A MODIFIED MOUNTING SCHEME
CUT
HERE
DISCARD
SHADED AREA
Figure 4A REVERSE SUPPORT BRACKET SCHEME
Figure F
"J" TYPE SPEED NUT
(ITEM #9)  REQUIRED
CUT
WINGBOARD
PANEL
CENTER THE HOLE IN THE
SPEED NUT OVER THE SLOT IN
THE WINGBOARD PANEL
⅜" SLOPE DOWN
STONE LEDGE
OUTSIDE WALL
CUT TO FIT DIMENSION "A"
AND BEND DOWN TO FORM A
VERTICAL LEG.
STONE LEDGE
⅜" SLOPE
DOWN
STRAIGHTEN TAB TO LAY FLAT
ALONG THE BOTTOM RAIL OF
THE SHELL
SECURE THE LONGEST SIDE OF
THE BRACKET TO THE SHELL
ADJUST IN OR OUT TO REST
ON LEDGE
SPRING STEEL
CLIP (ITEM #10) 
REQUIRED
3"
CUT EDGE
3"
DIMENSION "A"
SLIDE CLIP OVER
CUT EDGE OF
WINGBOARD
PANEL