Use; Notes On Use; Starting Use - Beurer EM 59 Heat Instrucciones De Uso

5. Use

5.1 Notes on use

• The device switches itself off automatically if it is not used for
one minute (automatic switch-off). When the unit is switched on
again, the LCD screen displays the menu selection and the most
recently used menu flashes.
• A brief acoustic signal is output when a valid button is pressed.
Two brief acoustic signals are output when an invalid button is
pressed.
• You can pause the stimulation at any time by briefly pressing the
ON/OFF button . To continue the stimulation, briefly press the
ON/OFF button again and set the desired impulse intensity
again.

5.2 Starting use

Step 1: Look for a suitable program from the program tables
(see section "7. Program overview").
Step 2: Place the electrodes on the desired area for treatment (for
positioning suggestions see section "7.4 Information regarding the
positioning of electrodes") and connect them to the device.
Step 3: Press the ON/OFF button
Step 4: Press the MENU button to navigate through the
/ menus and press the ENTER button to confirm
your selection.
˄/˅
Step 5: Use the setting buttons to select the program number
you want and press the ENTER button to confirm your selection.
At the start of the stimulation treatment, the impulse intensity of
and is set to 00 by default. No impulses are sent to the
electrodes yet.
to switch on the device.
Step 6: Use the left and right
to select the impulse intensity you want. The indicator for impulse
intensity in the display changes accordingly. If the program is in a
pause phase, the intensity cannot be increased.
Step 7: You can activate the heat function using the heat function
button. The first press of the button activates the low heat level,
the second button press activates the high heat level, and the third
button press deactivates the heat function.
General information
If you wish to return to the previous selection menu, press the
MENU button. By pressing and holding the ENTER button,
you can skip individual setting steps and start directly with the
stimulation treatment.
Keylock
Locks the buttons to avoid them being pressed unintentionally.
1. To activate the keylock, hold down the ENTER button until the
symbol is visible in the display (approx. 3 seconds).
2. To deactivate the keylock, hold down the ENTER button again
until the symbol disappears from the display (approx. 3 se-
conds).
Pausing use
/
You can pause the stimulation at any time by briefly pressing the
ON/OFF button . To continue the stimulation, briefly press the
ON/OFF button again and set the desired impulse intensity
again.
29
˄/˅
setting buttons for and