Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3
Assemble the Cleaner
1. Attach the feed hose connector
to the feed pipe by pressing it
down firmly until it locks.
2. The filter bag is packaged in
the collar area on the vacuum
tube. Pull out the bag, separate
the velcro strips, wrap it around
the hose and resecure with
velcro strips.
3. Turn on the pool filtration
pump and allow it to prime
before turning on the booster
pump. (Refer to booster pump
manufacturer's instructions for
booster pump priming time.)
4
Check for Proper RPM
Before operating the Polaris, check
for proper wheel revolutions per
minute (RPM).
For maximum efficiency, the cleaner
should operate between 30 and 36
RPM.
1. Mark the single-wheel
side tire.
2. Turn pump on, hold cleaner
below water level and count
wheel revolutions for one minute.
If count is not in target range,
refer to Adjusting the Wheel
RPM in the Troubleshooting
section for more information.
Hose
Single-wheel Side
Sweep Hose
Page 5
Bag
Feed Hose
Connector
Feed
Pipe
Tabla de contenido
