GE 21861 Manual Del Usuario página 5

Medium Speed 2
Medium Speed 1
Low Speed
This button controls the light and also
controls the brightness setting. Press and
release the button to turn the light ON or OFF.
Press and hold the button to set the desired
brightness: the light will slowly illuminate to
maximum light output and then stop when
holding the button, then release the button
and hold it again until it reaches minimal
illumination where it will automatically stop
again.The light button has an auto-resume,
it will stay at the same brightness as the last
time it was turned off.
- Lock/unlock switch when placed in the unlock position
position : The transmitter will send a common code, this transmitter will operate all other GE FANS with the same receiver
In the unlock
configuration.
position : Allows a unique code to be sent to the receiver in the fan. Only the receiver of this fan will be synced with this transmitter in
In lock
lock position. More than one fan can be synced with one transmitter, in this case-follow sync instruction for each fan.
NOTE:
-To prevent damage to transmitter, remove the battery if not used for long periods.
-Please contact your local batteries recycling center for proper battery disposal information.
4
Wall Control Operation
allows a common code to be sent .
Operation Indicator
High Speed
NOTE:
For convenience, the transmitter has been
preset by the factory in the unlock position.
With this setting the transmitter will work
with GE compatible fans without any
further programing.
" O " and " I " dim switch
For this fan, the dim switch should be in
the "I" position, allowing for dimming of
the light . Place the switch in the "0"
position to turn the dimming feature off
if you do not want the dimming feature.