Putting The Machine Into Service; Instructions For Use - Grillo G85-D Manual De Instrucciones

Track: external measurements: with tyres 4.00-8, 42 cm - with wide steel wheels, 36-44 cm.
Implements and attachments: tiller, double tiller, mower bar, snow thrower, plough, furrower,
lawn mower, grass shredder, irrigation pump, spraying pump, towed trailer, rotary tiller support
wheel, towing bar, tank mounted on dolly, wheel weights, metal wheels, weeder, container trailer,
rake, front scraper, biological grinding mill, sweeper.
1) Check that the machine has not been damaged in transit.
2) Fill with grease the machine PTO flanging all around the coupling (fig. 3 no. 20).
3) Select driving handlebar position according to the use, Walking tractor or Motormower, by using
the two levers (fig. 3, 4A no. 10 and no. 12).
4) Mount wheels and implement (e.g. rotary tiller, plough etc.) and tighten the securing nuts
completely.
5) Add engine oil, please refer to attached instruction booklet.
6) Add gearbox oil - fig. 6 (MP 80W 90 oil, or international equivalent API GL5 oil, US MIL-L-
2105D, quantity 2,2 litres for G85 and 1,9 litres for G85D and G107D.
7) Add oil into the air filter in oil bath (for versions provided with this type of filter), use the same oil
type as the engine oil (fig. 7A).
8) Insert the control levers (fig. 3 no. 13, no. 15 and no. 2).
9) Verify the tyre pressure according to the table provided below:
4.00-8
4.00-10
5.00-10
5.00-10
10) In the electric starting versions verify the battery voltage, it must not be lower than 12,5 V,
when required charge the battery, at 12,5 V on slow charge for 2 hours.
IMPORTANT!
During assembly take care not to get the polarity of the battery reversed.
11) Fill the tank with fuel using a funnel provided with a fine filter.
12) Check liquid levels when the machine is horizontal.
Before starting the engine always check:
−
the oil levels inside the engine (fig. 5, ref. A) and the gearbox; the level check cap is on the
upper cover (fig. 6); the oil level must be between the two notches.
−
that all screws and nuts are well tightened especially those fastening the attachments to the
machine.
−
that all levers are in neutral.
−
that the air filter (dry version) is clean (fig. 7). Caution! Never blow the cartridge with
compressed air; if clogged it must be replaced.
−
that the air filter (in oil bath version) is clean and its oil at the right level (fig. 7A).
−
check the oil level inside the tiller gearbox (fig. 4 no. 3)
−
fill the tank with fuel, using a funnel with very fine filter.
Translation of the Original Instructions

PUTTING THE MACHINE INTO SERVICE

TYRE PRESSURE
2 PLY RATING
2 "
2 "
2 "

INSTRUCTIONS FOR USE

"
"
"
10
1,1 BAR
1,1 "
1,5 "
1,5 "