Adjusting The Direction Of The Exhaust; User-Maintenance Instructions; Clearing A Jam From The Tool; Technical Service - Campbell Hausfeld SB504000 Manual De Instrucciones De Operación

Operating Instructions
Operating Instructions
(Continued)
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is equipped
with an adjustable
direction exhaust
deflector. This is
intended to allow
the user to change
the direction of the exhaust. Simply
twist the deflector to any direction
desired.
User - Maintenance
Instructions

CLEARING A JAM FROM THE TOOL

1. Disconnect the air
supply from the tool.
2. Remove all nails from
the magazine (see
Loading/ Unloading).
Failure to do so will
cause the nails to
eject from the front of the tool.
3. Loosen cap screws on nose of tool.
Slide nose downward and remove
from tool to expose jammed
fastener.
4. Reinstall nose assembly in reverse
order in Step #3.
5. Make sure the trigger and Work
Contact Element (WCE) move freely
up and down without sticking or
binding.
www.chpower.com

TECHNICAL SERVICE

Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this tool or
for additional copies of this manual.
FASTENER AND REPLACEMENT
PARTS
Rotate
18 gauge fasteners (or equivalent - see
Fastener Interchange Information).
Tool performance, safety and durability
could be reduced if improper fasteners
are used. When ordering replacement
parts or fasteners, specify by part
number.

TOOL REPAIR

Only qualified personnel should repair
the tool and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently.

ASSEMBLY PROCEDURE FOR SEALS

When repairing a tool, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
Use only genuine
reassembling, a few drops of 30W
Campbell Hausfeld
non-detergent oil or equivalent, must
be added through the air line before
testing.
STORAGE
The tool should be stored in a cool dry
place.
6
SB504000