Ryobi A25RT03 Manual Del Operador página 11

NOTE: The table leg with the English language warning
should go next to the switch box.
 Align the four holes in the legs with the four corresponding
threaded holes in the table.
 Insert the table leg screws through the holes and into the
table.
 Tighten screws with a screwdriver.
PRE-DRILLING HOLES FOR THROUGH TABLE
DEPTH ADJUSTMENT
See Figure 8.
Since each router will have different placements for through
table depth adjustments, pilot holes have been pre-drilled in
the throat plate to assist in through table adjustments. Only
the models listed below in the key are available for use with
the through table depth adjustment feature.
 Remove the throat plate.
 Determine which router you have and find the pre-drilled
pilot hole that matches your router. (Refer to the key below.)
 Using a drill and drill bit, drill a hole through the pilot hole large
enough for the depth adjustment tool (not included with
router table, but may be included with your router) to pass
though so through table depth adjustments can be made.
Figure 8 Key:
RD: RIDGID R2930, R22002
RY: Ryobi R163K, R163GK
ML: Milwaukee 5615-20, 5616-20
PC1: Porter-Cable 890 Series
PC2: Porter-Cable 8529
ATTACHING THE ROUTER TO THE TABLE
For ease of use, assemble the router to the insert plate with
the insert plate removed first, then install the insert plate/
router assembly into the router table.
ATTACHING THE ROUTER TO THE INSERT
PLATE
See Figures 9 - 10.
Remove the router insert plate screws from the blister pack.
Use these screws to attach the router insert plate.
 Unplug the router table and/or the router.
 Remove the insert plate.
 Remove the subbase plate from the router.
 Using the following chart for reference, and using one of
the three included sets of three router insert plate screws,
attach the router to the insert plate with the pilot holes
facing the router and the notch in the insert plate facing
the back of the router table.
NOTE: When attaching insert plate to the router, make
sure the holes in the router base match up with the insert
plate accurately and are not off-center.
ASSEMBLY
PRE-DRILLED
PILOT HOLES
11 - English
RD
ML
PC1
PC1
NOTCH
A1
NOTCH H
B4
A6
B1
B2
A5
A3
B3
A4
INSERT PLATE
SCREWS
INSERT PLATE
REAR SIDE
PC2
RY
Fig. 8
INSERT PLATE
FRONT SIDE
A2
Fig. 9
ROUTER INSERT
PLATE SCREWS
INSERT PLATE
Fig. 10
NOTCH
Fig. 11