Rewind Starter - Stihl HT 73 Manual De Instrucciones. Manual Del Usuario

If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
:
Remove spark plug as described
in chapter "Starting / Stopping the
Engine".
: Clean dirty spark plug.
:
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
:
Use only resistor type spark plugs
of the approved range.
Rectify problems which have caused
fouling of spark plug:
:
Too much oil in fuel mix.
:
Dirty air filter.
:
Unfavorable running conditions,
e.g. operating at part load.
Fit a new spark plug after approx. 100
operating hours
or earlier if the electrodes are badly
eroded.
HT 73
2
1
To reduce the risk of fire and burn
injury, use only spark plugs
authorized by STIHL. Always press
spark plug boot (2) snugly onto
terminal (1) of the proper size.
(Note: If terminal has detachable
SAE adapter nut, it must be
attached.) A loose connection
between spark plug boot and
ignition wire connector in the boot
may create arcing that could ignite
combustible fumes and cause a fire.
english / USA

Rewind Starter

To help prolong the wear life of the
starter rope, observe the following
points:
:
Pull the starter rope only in the
direction specified.
: Do not pull the rope over the edge of
the guide bush.
:
Do not pull out the rope more than
specified since it might break.
:
Do not let the starter grip snap back,
guide it slowly into the housing.
See also chapter "Starting /
Stopping the Engine"!
Replace a damaged starter rope in
good time or have it replaced by your
STIHL dealer!
29