Wagan Tech ELITE 200W PRO Manual De Usuario página 9

2. Connect the red (+) and black (−) terminals of the supplied DC Plug Adapter
Cord to the red (+) and black (−) terminals on the rear of the inverter.
Be sure to connect them into the correct polarity terminals on the rear
ƒ
of the inverter. Reverse polarity connection will blow the fuse in the
inverter and can permanently damage to the inverter. Damage caused
by reverse polarity will void the warranty.
3. Connect the Plug end of the DC Adapter Cable into your vehicle's 12V DC
accessory outlet. You may need to place the ignition switch to Accessory
Position if the vehicle engine is not operating.
4. Plug the AC appliance cord into the inverter's AC receptacle, and/or your
USB appliance into the USB power port.
5. Place the ON/OFF power switch in the "ON" position. The green LED
should turn on, indicating the inverter is powered and operating normally.
6. When the inverter is not in use, place the inverter's ON/OFF Power Switch
to the "OFF" position. We recommend also unplugging the DC Adapter
cable from the vehicle's DC outlet.
OPERATING ISSUES: TELEVISION AND AUDIO
EQUIPMENT SUGGESTIONS.
Although all inverters are shielded and filtered to minimize signal interference,
some interference with your television picture may be unavoidable, especially
with weak signals. However, here are some suggestions that may improve
reception.
• Make sure that the television antenna produces a clear signal under normal
operating conditions (i.e. plugged into a standard 110V/120V AC wall
outlet). Also ensure that the antenna cable is of good quality and properly
shielded.
• Sometimes vehicle alternators produce some electrical noise. There are
filters available to mount on the alternator to reduce the noise.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2019 Wagan Corporation. All Rights Reserved.
8