Tabla de contenido
Installation Procedure
2
Place the PDP side hardware on the spacers with its
holes aligned.
Top side of the plasma display
4
With the plasma display separated from
the PDP side hardware by spacers, fix the
plasma display to the hardware with bolt
M8 (4 locations).
Use the hole marked with a red "%" as the
standard.
If the angle of incline is increased, the top of the angle
adjustment use screw may be visible from a horizontal
position on the front. In this case, you can hide the top
of the screw by using the hole towards the top not
marked with a red "%".
For details see "Adjusting the Angle" on Page 12.
Top side of the plasma display
Note
If you plan to install speakers and cables, please install
them at this stage.
Do not connect the cables to the other device.
For the speaker installation method, refer to the
speaker installation procedure in the plasma display
operating instructions or the under speaker operating
instructions.
To install the under speaker in particular, first attach
hang the plasma display on the wall with only the
speaker installation hardware and the speaker cord
attached, then attach the under speaker. Refer to the
under speaker operating instructions for the method of
attaching the speaker installation hardware and the
speaker cord.
10
En
PDP side hardware
5
Attach the wall side hardware to the wall.
Install the wall side hardware (4 locations)
symmetrically on the left and right side (one
at each location from the center of the
). Because the screws and bolts used
to do this are different according to the wall
strength and wall material, purchase
suitable screws and bolts separately.
Note
Check the strength of the wall and beams before
installing the display.
6
Attach the hook on the ceiling side of the
PDP side hardware to the wall side
hardware.
1
First turn the screw in the center of the PDP side
hardware in the direction that opens it to raise the
tilted part then attach the hook so that the
attachment part is visible.
2
Attach the attachment part firmly, then check to
make sure that the plasma display has been
horizontally attached in the correct position.
Note
Do not hold the speakers during the installation work.
Hook
Closing
Always have at least 2 people do this task.
Always make sure that the hook has been
Caution
hung.
Opening
Tabla de contenido
