Operation - Ryobi P2108 Manual Del Operador

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please call 1-800-860-4050 or contact an
authorized service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 Trimming and shaping hedges and shrubbery
This product will accept Ryobi One+ 18 V lithium-ion battery
packs and Ryobi One+ 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator's
Manuals for your Ryobi One+ battery pack and charger
models.
INSTALLING DEBRIS DEFLECTOR
See Figure 2.
NOTE: Always wear non-slip, heavy-duty gloves when in-
stalling or removing the debris deflector.
 Remove the battery pack.
 Place the hedge trimmer on a sturdy flat surface.
 Align the angled edge of the debris deflector with the
grooves on the guide bar.
 Slide the deflector completely onto the guide bar so the
angled edge of the deflector rests beneath the guard.
 Insert the deflector retainer in the end of guide bar.

OPERATION

WARNING:
Never use the debris deflector as a handle or attempt to
hold or guide the hedge trimmer by gripping the debris
deflector. Always keep both hands on the hedge trimmer
handles. Improper handling of hedge trimmer could result
in serious injury.
TO INSTALL / REMOVE BATTERY PACK
See Figure 3.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
hedge trimmer before beginning operation.
NOTICE:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the bottom of the tool and
latches into place properly. Improper installation of the
battery pack can cause damage to internal components.
To remove:
 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
hedge trimmer.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked with hands free of the
lock-out button when not in use. Remove battery pack
when transporting or carrying hedge trimmer to avoid
accidental starting, which may result in serious injury.
8 — English