Campbell Hausfeld CS Serie Instrucciones De Operación página 16

Ocultar thumbs Ver también para CS Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operating Instructions
Maintenance (Continued)
Dispose of the used oil, oil-contaminated
container, and cloths in accordance with
local regulations.
3. Oil the seal on the new air-oil separating element with
oil of the same oil type as in the compact module screw
compressor.
4. Tighten the new air-oil separating element by hand. No tool is
required.
5. Switch on the compressor system.
6. The air-oil separating element must be checked for leaks with
the system running.
Air-Oil
Separating
Elements
Figure 13 - Air-Oil Separating Element
FILLING WITH OIL
Make sure to use recommended oil. Add oil
of the same oil type from the same
manufacturer. Switching over to another oil type can require
fl ushing of the screw compressor.
NOTE: Replace the oil filter with every oil change.
1. Switch off the system, prevent it from being switched back
on without authorization.
2. Through the filler neck on the separating tank, add oil up to
the maximum level and reinsert the screw plug, turning firmly
onto the filler neck by hand.
3. Switch on the screw compressor and allow it to run for
approximately three minutes.
4. Switch off the system, prevent it from being switched back
on without authorization.
5. Top off the oil to the maximum level.
6. Switch on the screw compressor and return to normal use.
16
www.campbellhausfeld.com
AIR INTAKE FILTER
Do not remove air fi lter housing or perform
any maintenance with pressure in the air
end or air pressure tank.
Never run the compressor pump without an intake air filter or
with a clogged intake air filter. The air filter element should be
checked monthly (see Figure 14). Operating compressor with
a dirty filter can cause high oil consumption and increase oil
contamination in the discharge air. If the air filter is dirty it must
be replaced.
In case of heavily soiled intake air, replace and check more
frequently.
Dirt and dust particles must not be
permitted to get into the air inlet of the
compressor module. Air intake must be clean and maintained.
It is not permissible to clean the fi lter
element; the fi lter element must always be
replaced! Dispose of the old air fi lter element according to local
regulations.
1. Switch off the screw compressor system and prevent it from
being switched back on without authorization.
2. Screw off the wing nut and remove the filter cover.
3. Remove the old filter element.
4. Carefully remove dust from the filter housing.
5. Insert the new filter element in the filter housing.
6. Install the filter cover, ensuring proper positioning during
assembly.
7. Tighten the wing nut.
8. Switch on the system.
Wing Nut
Filter Cover
Filter Element
Figure 14 - Air Intake Filter
OIL COOLER
Weekly, check the oil cooler to be sure all fittings are secure and
tight. Clean all dirt, dust and other accumulations.
Tabla de contenido
loading

Tabla de contenido