Campbell Hausfeld CS Serie Instrucciones De Operación página 11

Installation (Continued)
LUBRICATION
THIS UNIT CONTAINS OIL. Before operating
compressor, check oil level (see Figure 7).
Using any other type of oil may shorten
pump life and result in damage.
Recommended Oil
Single viscosity ISO46 rotary screw compressor oil (Part
number CS0030 - 1 Gallon Container). Available from
Campbell Hausfeld, please call 1-855-504-5678 for customer
assistance.
Oil Capacity
2.1 gallons
OIL LEVEL
Disconnect, tag and lock out
power source then release
all pressure from the system before attempting to
install, service, relocate or perform any maintenance.
RISK OF BURNS! The unit parts,
oil, and screw plug can be hotter
than 175° F (80° C)! Wear personal safety equipment!
Power Indicator
(WHITE)
ON / OFF Switch
[Lighted when in
ON position
(GREEN)]
Figure 8 - Control Panel
Series CS Rotary Screw Compressors
Oil Plug
Maximum
(cold oil level)
Minimum
(cold oil level)
Figure 7 - Oil Level
With hot oil, the oil level can be
approximately 3/4 inch higher than with
cold oil shortly after discharging.
An important factor for the operating safety of the compressor
system is the oil level in the oil reservoir. The oil level check
must be performed before initial operation of the compressor
and then repeated every 100 operating hours.
E-Stop
High Temperature /
High Pressure
Indicator Light
and Reset (RED)
Hour Meter
www.campbellhausfeld.com
11