Fitting The Carrying Eye - Stihl FS 55 Serie Manual De Instrucciones

English / USA
8
8
7
7
4
3
5
6
1
1
Loop handle without barrier bar
: Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
: Fit the clamp (6) and line up the
holes.
: Fit washers (7) on screws (8).
: Insert screws (8) in holes and screw
on the square nuts (1) as far as
stop.
: Go to "Securing the loop handle".
20
A
9
10
Securing the loop handle
: Secure the loop handle (4)
approx. 8"/20cm (A) forward of
the control handle (9).
: Line up the loop handle.
: Tighten down the screws firmly –
lock the nuts if necessary.
10= Sleeve*
* see "Guide to Using this Manual"

Fitting the Carrying Eye

4
: For position of carrying eye
"Parts and Controls"
: Place the clamp (1) with the
tapped hole on the left-hand side
of the drive tube.
: Squeeze the two ends of the clamp
together and hold in that position.
: Insert M 6 x 14 screw (2).
: Line up the carrying eye.
: Tighten down the screw firmly.
1) Included as standard or available as
special accessory
1
1
2
1)
see
FS 55