Makita XDT01 Manual De Instrucciones página 7

Empty signal for remaining
battery capacity
014071
Pulling the trigger switch when the remaining battery
capacity becomes very low makes LED indicator flicker.
If the tool is used continuously with the LED indicator
flickering up and the battery power is almost used up,
the LED indicator will light up and the tool itself will stop.
Please refer to the following table for the LED indicator
status and the remaining battery capacity.
LED indicator status
OFF
Flickering
Lighting on
011188
NOTE:
When all lamps on the switch panel go out, the
•
tool is turned off to save the battery power. The
remaining battery capacity can be checked by
pulling the switch trigger to the extent that the tool
does not operate.
All of the lamps on the switch panel go out
•
approximately one minute after releasing the
switch trigger.
When the tool temperature is high, the LED
•
indicator may flicker or light up.
If the LED indicator lights up and the tool stops
•
even with a recharged battery cartridge, cool down
the tool temperature fully. When the status is still
unchanged, stop using and have the tool repaired
by a Makita local service center.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
1. LED indicator
S H
1
Remaining battery capacity
Enough
20%
Very low and the tool will stops
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1
2
009205
To install the bit, insert the bit into the sleeve as far as it
will go.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as far as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
014068
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
7
9 mm
(3/8")
1. Bit
2. Sleeve
1. Groove
2. Hook
1
3. Screw
2
3