Getting Started - Ribimex Ribitech PRSOUDKIT Manual De Instrucciones

The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
22. Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part
in an authorized service centre is recommended.
This electric tool is in accordance with the relevant safety requirements. Repairs should only
be carried out by qualified persons using original spare parts, otherwise this may result in
considerable danger to the user.
23. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
SPECIAL WARNINGS WHEN USING THE PRODUCT
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
4. Use only accessories adapted for the head of the soldering iron/gun.
5. Do not use tool if damaged.
6. Never seize the heating tip during operation
7. Always stop and disconnect the tool and allow it to cool down before leaving it.
8. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect
plug from its main power source. Do not touch the cable or extension cord before unplugging from
main power.
9. Before use, always inspect soldering iron/gun.
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form
its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Inserting and removing a tip (1)
- Unscrew the screw (2)
- Insert a tip (1).
- Tightly screw the screw (2)
- Check that tip is correctly inserted and tightened.
4.3- Operation (on and off)
4.3.1- For the iron
- To start the soldering iron: connect cable plug to mains.