Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before assembling this tool, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to assemble the tool.
Estimated Assembly Time: 1 – 3 minutes
Tools and Materials Required for Assembly (not included):
•
3/4 in. (19 mm) wrench
•
9/16 in. (14 mm) or adjustable wrench
•
Thread sealant tape
•
Tool oil
•
Male plug
ASSEMBLY
1. Remove plastic air inlet protective cap
from air inlet
7
.
NOTICE: The air inlet
two wrenches are required to insert the
male plug.
2. Insert the male plug (not included)
into the air inlet . Using a 3/4 in.
(19 mm) wrench (not included) hold
the air inlet nut , and tighten the
7
male plug by turning it clockwise
using a 9/16 in. (14 mm) wrench (not
included) for an air tight connection.
DO NOT OVERTIGHTEN.
NOTICE: Use threaded sealant tape (not
included) on the threading of the male
plug.
7
will spin freely, so
7
7
7
ENGLISH
7
Tabla de contenido
Solución de problemas
