Use - Casselin CDEC68 Manual De Instrucciones

ELECTRICAL HAZARD
Danger from electric current !
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
Before using the appliance, clean it thoroughly with a non-abrasive detergent.
Place the unit upright on a solid, flat surface.
Fill the drinking water tank up to the maximum level (or below but never above).
Be sure to respect the minimum and maximum levels.
Close the cover (by turning it clockwise to lock it)
Switch on the device by pressing the ON / OFF button.
The red heating indicator light comes on.
Adjust the thermostat to obtain the desired temperature.
Depending on the desired preparation (tea, instant coffee, instant soups, hot wines, etc.) it is important to
adapt the temperature.
Wait until the water has reached the desired temperature, then the red heating indicator light goes out and
the green temperature maintenance indicator light comes on.
You can consume the liquid at the programmed temperature. To do this, place a container on the removable
cup rest and activate the tap.
After use, place the power button in the OFF position, unplug the appliance and empty the remaining liquid
using the tap.
Beware of the risk of burns.
Never open the cover during use : hot steam is dangerous.
During operation, the walls of the appliance can reach temperatures and cause the risk of burns. It is therefore
recommended not to touch them without protection.
NOTE
To completely empty your device once the liquid has cooled, tilt your device slightly and pour in the remaining
water.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
EN