Equipment Description; Alarm Station; Luminous Button; Ako-52213/14 Gas Detector - AKO -522034 Manual Del Usuario

3.- Equipment description

Alarm station

VISUAL ALARM
INPUT INDICATORS
INPUT IDENTIFICATION
LABEL
MODBUS ADDRESS
SELECTOR
PRE-ALARM JUMPER
Input identification label
We recommend filling in the input identification label included with the station
to optimise alarm origin identification.
Pre-alarm jumper
It allows activating pre-alarm detection.
Before using this option, make sure that
regulations allow for only two alarm levels.
When using the ammoniac (AKO-52213) or CO (AKO-52215) detector, the pre-alarm must be
enabled.

Luminous button

In stand-by, the button's luminous indicator will be
permanently on even though the power supply fails, as
long as the battery is not flat.
Press the button to activate the alarm, and to deactivate it
turn the button clockwise until it is released.

AKO-52213/14 Gas detector

Delay switch
It delays the activation of alarms detected in the station.
The detector status indicators will indicate the alarms and
pre-alarms immediately, without taking into account the
delays.
ON
Without delay*
ON ON
60 sec.
IMPORTANT: The delay configuration should be carried out with the station's power supply
disconnected, as if not it will not work.
ALARMS
1
2
3
4
1 2 3 4
Pre-alarm enabled
Pre-alarm disabled
ON ON
30 sec.
ON ON
120 sec.
16
POWER SUPPLY STATUS
MUTE/RESET BUTTON
AUTO-CONFIGURATION
ALARMS
1
2
3
4
2
LUMINOUS BUTTON
ALARM BUTTON
STATUS INDICATORS
DELAY SWITCH
ACOUSTIC ALARM
BUTTON
Compressor
room
Cold
room 1
Workshop
1 2 3 4
* Default value