Tabla de contenido
TrOuBLESHOOTinG GuidE
TROUBLE
SUGGESTED REMEDY
1. If fan does not start:
1. Check main and branch circuit fuses or circuit breakers.
2. Check wire connections as performed in step #6 or #7 of installation.
CauTiOn: Make sure main power is turned off.
3. Make sure forward/reverse switch is firmly in up or down position.
Fan will not operate when switch is in the middle.
4. If the fan still will not start, contact a qualified electrician.
Do not attempt to troubleshoot internal electrical connections yourself.
1. Check to make sure all screws in motor housing are snug (not over tightened).
2. If fan sounds noisy:
2. Check to make sure the screws which attach the fan blade holder to the motor are tight.
3. If using an optional Ceiling Fan Light Kit, check to be sure the screws securing the glassware are finger tight.
Check to be sure light bulb is tight in socket and not touching glass shade(s). If vibration persists from glass,
remove glass and install a 6mm wide rubber band on glass neck to act as an insulator. Replace glass and tighten
screws against rubber band.
4. Some fan motors are sensitive to signals from Solid State variable speed controls.
DO NOT USE a Solid State variable speed control.
5. Allow "break-in" period of 24 hours. Most noises associated with a new fan will disappear after this period.
All blades are weighed and grouped by weight. Natural woods vary in density which could cause the fan to wobble even
3. If fan wobbles:
though all blades are weight-matched. The following procedures should eliminate most of the wobble. Check for
wobble after each step.
Touching
1. Check that all blades are screwed firmly into blade holders.
Ceiling
2. Check that all blade holders are tightened securely to motor.
3. Make sure that canopy and mounting bracket are tightened securely to ceiling joist.
4. Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a point on the
Figure 1
ceiling above the tip of one of the blades.Measure this distance as shown in Figure 1. Keeping measure within
3mm, rotate the fan until the next blade is positioned for measurement. Repeat for each blade. If all blade levels
Blade Tip down:
are not equal, you can adjust blade levels by the following procedure. To adjust a blade tip down, insert a washer
Fan Blade
(not supplied) between the blade and blade holder at the screw closest to the motor (Figure 2). To adjust a blade
Blade Brackets
tip up, insert washer (not supplied) between the blade and blade holder at the two screws farthest from the
Blade Tip up:
motor (Figure 2).
Fan Blade
5. If blade wobble is still noticeable, interchanging two adjacent (side by side) blades can redistribute the weight
and possibly result in smoother operation.
4. If light does not work:
1. Check to see that the wire connections in the switch housing are connected.
2. Check for faulty light bulbs.
3. If light kit will still not operate, contact a qualified electrician for assistance.
If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some
cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting chart.
If a problem cannot be remedied, please consult with your qualified electrician and do not attempt any electrical repairs yourself.
13
13
ETL-ES-GW-Contempra-WH17
Tabla de contenido
