Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Features
6
A
Status LED Color
A
Off
Steady Green
Flashing Amber
7
Configuration Port: Use this port to provide direct terminal connection to a computer with a
terminal emulation program. A serial cable is included with the ATS. If you need to order a
replacement cable, contact Tripp Lite Customer Support at www.tripplite.com/support.
8
ENVIROSENSE Port: Use this port to connect a Tripp Lite ENVIROSENSE environmental
sensor to provide remote temperature/humidity monitoring and a dry contact interface to
control and monitor alarm, security and telecom devices. Visit www.tripplite.com for ordering
information.
Note: Do not connect a keyboard or mouse to this port.
9
Circuit Breaker: Each single phase output load has its own magnetic breaker. If the
connected equipment load exceeds the maximum load rating for that phase, the circuit
breaker will trip. Disconnect excess equipment before resetting the breaker(s).
10
Chassis Ground Screw: Use this to connect equipment that requires a chassis ground.
11
ATS Mating Receptacle: This receptacle only accepts the 8-position connector on the power
strip input power cord.
15-01-272-9333FB.indb 7
Network Interface: Use the RJ-45 jack to connect the ATS to the network
with a standard Ethernet patch cable. The Status LED
B
indicate operating conditions as shown in the table below. These ports are
not compatible with PoE (Power Over Ethernet) applications.
Network Operating Conditions
Card Not Initialized
Card Initialized and Operational
Error - Card Not Initialized
Link LED Color
B
Off
No Network Connection
Flashing Amber
100 Mbps Network Connection
Flashing Green
10 Mbps Network Connection
7
and Link LED
A
B
8/26/2015 10:04:16 AM
Tabla de contenido
