Fault Finding - Trust TOMY Digital SR200 Manual De Instrucciones

• FAULT FINDING

PROBLEM POSSIBLE CAUSE
My Parent Unit will not The rechargeable battery supplied has
switch ON. not been installed correctly.
The rechargeable battery may be below the
critical voltage to activate your monitor.
Mains power is not connected correctly.
My Baby Unit will not Mains power is not connected
switch ON. correctly.
The Power ON/OFF Button is not being
held long enough.
There is a continuous Loss of contact alarm.
beeping noise from the
Parent Unit.
An alarm beeps 3 times Low battery in the Parent Unit.
every minute from the
Parent Unit.
Volume on Parent Unit is set too low.
I cannot hear anything
through my Parent Unit.
And/or its sound is only Units are set to Sound Activated
Monitoring mode.
intermittent.
Units are set to Sound Activated
Parent Unit is switched ON,
Monitoring mode.
but the sound level lights
and audio are all off.
I hear a high-pitched Units are too close together.
noise.
Volume is too high.
Low battery.
Power Indication Light
on the Parent Unit is
blinking red.
As with any rechargeable battery,
Battery life after
it has a finite life and may need
charging is becoming
replacing.
shorter.
Radio waves from other devices may be
I cannot hear the baby's
affecting your monitor.
sound clearly because
of static.
GB
SOLUTION
Insert the battery as instructed within this booklet or the
Quick Start Guide. Once installed, place the Parent Unit on
charge and leave for several minutes before switching ON.
Place the Parent Unit on charge and leave for several
minutes before switching ON.
Check the power cable connections
(including wall socket).
Check the power cable connections
(including wall socket).
Press and hold the Baby Unit's Power ON/OFF Button
until the Power Indication Light illuminates.
Make sure that the Baby Unit is switched ON.
Make sure the Parent Unit is adequately powered
and move it nearer to the Baby Unit.
Place the Parent Unit on charge.
Increase Parent Unit volume.
Refer to the Sound Activated Monitoring section.
Refer to the Sound Activated Monitoring section.
Move units apart.
Decrease volume.
Place the Parent Unit on charge.
Please visit our website for replacement parts.
www.tomy.eu
This product has Auto-Channel Selection feature. If
you experience static sound, place the Parent Unit
closer to the Baby Unit. If this does not solve the
problem, move your Parent Unit away from other
2.4GHz devices such as microwave ovens, wireless
phones or a wireless access point.
6
PAGE
3
3
3
3
4
4
3
3
5
3
7