Troubleshooting - Mi-T-M Corporation GEN-1100-0MS0 Manual Del Operador

When generator engine fails to start after several attempts, or if no electricity is available at the output socket, check
the following chart. If your generator still fails to start or generate electricity, contact your nearest Mi-T-M dealer or
service shop for further information or corrective procedures.
Symptom
Engine will not start.
Generator has no output.
(Output Lamp is ON)
Generator has no output.
(Output Lamp is OFF)
Operator's Manual

Troubleshooting

Problem
Check if engine switch is off.
Fuel Tank empty.
Check to make sure generator is not
connected to an appliance.
Check spark plug for loose spark
plug cap.
Check spark plug for contamination.
Check engine oil level.
Check the AC and DC breakers.
Check if the DC circuit breaker is
turned off.
Check to see if the engine was started
with appliances already connected to
the generator.
Low power.
Solution
Turn engine switch to the "
(CHOKE) position.
Fill tank making sure not to overfill.
If connected, turn off the power switch
on the connected appliance and
unplug.
If loose, push spark plug cap back
into place.
Remove spark plug and clean
electrode.
If the engine oil level is low, add oil
per "Pre-Operation; Engine Oil" on
page 2.
Depress the circuit breaker into the ON
position, after making sure the electric
power level is proper and the electric
appliance (s) are in the normal
condition.
Turn off the appliance, and disconnect
cable from receptacle. Reconnect
after the generator has been started
properly.
Carbon brushes are excessively worn,
contact an authorized Mi-T-M
Service Center or Dealer.
Contact an authorized Mi-T-M
Service Center or Dealer.
"
3