Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Recommended fitting type for
back-to-back installations.
1
3
Apply weight evenly.
Do not move after
placement. Water
tight seal may break.
5
A
Connect water
supply line. (Sold
separately) Hand
tighten nut.
B
Turn on
water supply.
7302312-100 Rev. A 4/17
BACK-TO-BACK INSTALLATION
Depending upon your plumbing and venting conditions, the flow from the
toilet in a back-to-back installation may create a vacuum on the system and
draw water from the opposing bowl. The National Standards Plumbing Code
prohibits the use of a cross fitting for drainage as throw over is possible. The
code does approve a directional "Y" style fitting with proper venting to direct
the water downward and away from the other toilet.
2
4
2
Press firmly.
Hand tighten
!
only. Do not
overtighten.
WARNING: Overtightening of water supply line
!
nuts could result in breakage and potential
flooding. If the connection leaks after hand
tightening, replace the supply line. Do not use any
type of sealant on the water supply connection.
Use of plumber's putty, pipe dope, or any other
type of sealant will void the warranty.
WARNING: Do not use plumber's putty, pipe dope,
!
or any other sealant on the water supply connection
to this tank. If the connection leaks after hand
tightening, replace the supply line. If the connection
continues to leak with the new supply line, replace
the fill valve. Warranty is void if any type of sealant
is used on the water supply connection.
Wax Ring
Tabla de contenido
