Refueling The Chain Saw - Stihl MS 462 C-M Manual De Instrucciones

13 Mixing Fuel and Refueling the Chain Saw
► Depending on the required amount of fuel, determine the
correct amounts of 2-cycle engine oil and gasoline in a mix
ratio of 50:1. Examples for fuel mixes:
– 1 US gals of gasoline: 2.6 oz. of 2-cycle engine oil
– 2.5 US gals of gasoline: 6.4 oz. of 2-cycle engine oil
– 5 US gals of gasoline: 12.8 oz. of 2-cycle engine oil
► When mixing, pour oil into the container first, and then add
gasoline. Close the container and shake it by hand to
ensure proper mix of oil and gasoline.
► Dispose of empty mixing-oil containers only at authorized
disposal locations.

13.2 Refueling the Chain Saw

WARNING
Removing the fuel cap on a pressurized fuel tank can result
in gasoline, vapors and fumes being forcefully sprayed out
from the tank in all directions. The escaping gasoline, vapors
or fumes, sometimes referred to as fuel spraying or
"geysering," can cause serious personal injury, including fire
and burn injury, or property damage, @ 5.5.
WARNING
Fuel spraying can occur when the engine is hot and the tank
is opened while under pressure. It can occur in hot
environments even if the engine has not been running.
0458-790-8621-A
Spraying is more likely to occur when the fuel tank is half full
or more. Always follow the fueling instructions in this
manual:
– Treat every fuel tank as if it is pressurized, particularly
if it is half full or more.
– Always allow the chain saw to cool adequately before
attempting to open the fuel tank or refueling. This will
take longer in hot conditions.
– Never remove the cap by turning it directly to the open
position. Turn it first approximately 1/8 of a turn
counter-clockwise to the vent position to relieve any
residual pressure.
– Never open the fuel tank while the engine is still hot or
running.
– Never open the fuel tank or re-fuel the saw near any
sparks, flames or other ignition sources.
– Pick the right fuel: use only good quality (89 octane or
higher), fresh fuel blended for the season.
– Vapor lock: do not remove the fuel cap in an effort to
relieve vapor lock. Removing the cap has no effect on
vapor lock.
– Be aware that fuel spraying is more likely at higher
altitudes.
Opening and Refueling
To refuel the chain saw:
► Shut off the engine, @ 15.
► Engage the chain brake, @ 12.1.
► Allow the chain saw to cool. Never attempt to remove the
cap while the engine is still hot or running.
► Position the chain saw on a level surface with the fuel filler
cap facing upwards.
► Clean the area around the fuel filler cap with a slightly
dampened cloth.
English
41