Connecting The Cold Water Supply - brondell SouthSpa LH-20 Manual De Usario

PRODUCT INSTALLATION (cont.)

CONNECTING THE COLD WATER SUPPLY

1 . Remove existing toilet seat
a . Lift hinge covers and use flathead or Phillips
head screwdriver to remove the mounting
bolts . Alternatively, you may need to loosen
mounting bolts underneath the seat .
b . Remove the toilet seat and set the seat,
mounting bolts and hardware aside .
2 . Turn off water supply valve and flush toilet
a . Turn off water supply at the wall to stop flow of
water .
b . Flush toilet and hold down handle to
completely empty toilet tank .
c . Disconnect water supply hose from the fill
valve under the toilet tank .
3 . Connect 7/8" T-Valve to Water Supply Line and
Fill Valve Under Toilet Tank .
a . Install the 7/8" T-valve with one or both of
the rubber washers to the incoming water
connection on the bottom of your toilet tank .
b . Connect the cold water supply line coming
from the wall to the bottom of the T-valve .
6
Step 1b
Step 2c
Step 3a
Step 3b