Connecting The Hot Water Supply - brondell SouthSpa LH-20 Manual De Usario

PRODUCT INSTALLATION (cont.)

CONNECTING THE HOT WATER SUPPLY

1 . Connect the hot water supply
a . Locate the hot water supply line in your
bathroom under your sink/washbasin and turn
the water supply valve all the way off .
b . Drain the hot water line by turning on the sink
tap on the hot setting until no more water
comes out .
c . Disconnect hot water supply hose to sink from
shut off valve . You may have to use a 3/8"
compatible wrench or a similar tool
(not supplied) .
Note: there may be some residual water in the
hose, use a small container or towel to catch
any residual water.
2 . Install the Hot Water 3/8" T-valve and the small
rubber washers as needed onto the hot water
shut off valve under the sink .
3 . Reconnect hot water supply line to open end
(top) of T-valve .
8
Step 1c
Steps 2 and 3