wilux Trioclean Manual De Instrucciones página 13

Istruzioni Trioclean 02-03-2004 09:43 Pagina 13
Introduction:
If the system is under tension Led G is on. All keys can be selected now. Fill the bath untill
approximately 10 cm. over of the lateral jets. The ideal watertemperature is 37/38ºC. When
there will be enough water in the bathtub, Led E won't be illuminated anymore and you
can activate any function.
The water and air massage can be activated individual as well as combinated. The system
works with 230V – 50 of 60Hz.
Water pump functioning:
To activate the water pump please press key ON/OFF HYDROMASSAGEPUMP,ddd its
functioning is independent from other functions apart from cleaning. The water pump is
only working if there is enough water in the bathtub (indicated by Led E). You can regulate
the airflow towards the water jets turning the whole knob to the left (less air) or to the right
(more air). To stop the water pump press the key ON/OFF HYDROMASSAGEPUMP again
(1-di.
Blower functioning:
The blower can be operated in 2 ways: constant speed or wave simulation (in this case the
blower is never stopped completely and the speed varies from minimum to maximum and
back). To activate the blower press ON/OFF BLOWER segn..) The two functions are run by
the key INCREASE/DECREASE BLOWER SPEED segn). When pressing this key you can
adjust blower speed from minimum to maximum and back. To activate the wave simulation
press ADJUST BLOWER PULSATING SPEED seg ), a wave cycle lasts approximately 6
seconds during which the speed will vary continuously from maximum to minimum and vice
versa. To deactivate the blower press ON/OFF BLOWER segno.
During the cleaning cycle the blower cannot be activated. If the bathtub is empty only the
blower can be activated. In this way you can blow dry the tubes of the air system. To dry the
tubes you have to wait 15 minutes after emptying the bathtub.
Spotlight functioning:
As the water pump, the spotlight works only with enough water in the bathtub (indicated
by Led E). If Led E is on, this means that the spotlight has been activated and there is
enough water inside the bathtub, when it is off, the spotlight has been switched off but
there is still water inside the bathtub. Should Led E blink, the spotlight has been switched
off and the bathtub is empty or not full enough. To switch on and off the spotlight press
ON/OFF SPOTLIGHT segn).
Cleaning cycle:
This function can be activated by pressing the key ACTIVATE CLEANING CYCLE segno
for 3 seconds. It only functions with enough water in the bathtub and enough disinfection
liquid in the tank. All the other functions must be switched off. If Led F blinks, there is not
enough disinfection liquid in the tank and you have to add the liquid. When you press the
ACTIVATE CLEANING CYCLE knob an acoustic signal will be activated and at the same
time the spotlight will start blinking to indicate that disinfection fluid will be injected in the
bathtub (until the spotlight is blinking you can still stop the disinfection program by
13