7.4.2 CLEARING OF ALL LEARNED KEYS
1. Press and hold [MUTE] and [VOL+] keys for 3 seconds until the LED will be
lit.
2. Enter the code [9] [8] [2], the LED will flash
2 times and then remain on.
3. Press and release the [SETUP] key at the
Universal Remote Control. If the LED flashes 3 times, all commands have
been cleared successfully.
8. Maintenance
• Do not mix new and used batteries for powering the Universal Remote
Control, as old batteries tend to leak and may cause power drain.
• Do not use corrosive or abrasive cleaners on your Universal Remote Con-
trol.
• Keep the Universal Remote Control dust free by wiping it with a soft, dry
cloth.
9. Troubleshooting
Q. My Universal Remote Control does not work at all!
A. Check your TV/STB device. If the device's main switch is turned off, your
URC cannot operate your device.
A. Check whether your batteries are inserted properly and are in the correct
+/- position.
A. Check whether you have pressed the corresponding device mode key for
your device.
A. If the batteries are low, replace the batteries.
Q. If several Device Codes are listed under the brand of my TV/STB device,
how
can I select the correct Device Code?
A. To determine the correct Device Code for your TV/STB device, test the codes
one by one until most keys work properly.
Q. My TV/STB equipment responds only to some of the commands.
A. Try other codes until most keys work properly.
10. Service and Support
If you have questions on the product, you are welcome to contact Hama
Product Consulting.
Hotline: +49 9091 502-0
For further support information please visit:
www.hama.com
11. Recycling Information
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and
2006/66/EU in the national legal system, the following applies:
Electric and electronic devices as well as batteries must not be
disposed of with household waste. Consumers are obliged by law to
return electrical and electronic devices as well as batteries at the end
of their service lives to the public collecting points set up for this purpose or
point of sale. Details to this are defined by the national law of the respective
country. This symbol on the product, the instruction manual or the package
indicates that a product is subject to these regulations. By recycling, reusing
the materials or other forms of utilising old devices/Batteries, you are making
an important contribution to protecting our environment.
14