Learn Mode - Hama 179809 Instrucciones De Uso

5.3 CODE INQUIRY
Use the following method to find out which code is currently set:
1. Press and hold [MUTE] and [POWER] keys for approx. 3 seconds until the
LED will be lit.
2. Enter the code [9] [9] [0] (The LED will flash once for each enter) with the
number keys. The LED will flash twice and goes off.
3. Press the key [1] for the 1st digit of the code. The LED will start to flash.
Count the LED flashes. The number of flashes resemble the code's first
digit.
Repeat this procedure for the 2nd and 3rd digit of the code:
2nd digit -> press the key [2] -> count LED flashes
3rd digit -> press the key [3] -> count LED flashes
If code number is 0 the LED will not flash. After the LED has indicated the
third digit it will turn off.
5.4 Compatible Remote Control Model
Due to too many remote control models, we only Iist some of them below.
lf your remote control is similar to the drawing, the replacement remote can
control your TV (Page 47).

6. LEARN MODE

This remote control is equipped with a learning function. Thus, you could learn
functions of your original remote to this remote control.
6.1 BEFORE STARTING LEARN MODE
• The batteries in the two remote controls have to be in good condition.
Replace them if necessary.
• Place the remote controls with the infrared diodes so that they point towards
each other.
• Where necessary adjust the height of both remotes so that infrared diodes are
properly aligned.
• The distance between the remote controls should be about 3 cm.
ROC1117GRU
HAMA
Note
• Do not move the remote controls during the learning procedure.
• Ensure that the room is not lit by fluorescents tubes or low energy consump-
tion lamps since such light sources could interfere with the copying.
• The 2 remote controls must be at least
1 meter away from any light source.
• During learning mode, if no key is selected for more than 15 seconds, the
learning mode will exit automatically or
if no other remote signal is received.
• Each function key will hold only one command. A new command to be
learned will automatically replace the previous one.
6.2 ENTER LEARN MODE
1. Press and hold the [MUTE] and [VOL+] keys for approx. 3 seconds until the
LED will be lit.
2. Enter the code [9] [8] [0], the LED will flash 2 times and then remain on.
3. The remote control is now ready to learn new commands.
6.3 LEARNING OF KEYS
1. Press and release the desired key on the original remote control which you
want the command to be learned. The LED at your replacement remote will
flash to confirm that the information has been received.
2. Then press and release the target key on the remote control you want
learned.
3. If the LED flashes 3 times and then remain on, the command has been
learned successfully.
4. Repeat these steps to learn other key functions.
5. Please press the [OK] key to save the code and exit learning mode.
Note
• While replacing the batteries, the remote control will keep the functions of
the learned keys.
ORIGINAL
ca. 3 cm
9