Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
014078
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel, multi disc)
CAUTION:
The wheel guard must be fitted on the tool so that
•
the closed side of the guard always points toward
the operator.
1
2
014012
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard to such an angle that it can
protect the operator according to work. Be sure to
tighten the screw securely.
To
remove
wheel
procedure in reverse.
1. Wheel guard
2. Bearing box
3. Screw
3
guard,
follow
the
Installing or removing depressed center
grinding wheel/Multi-disc
014084
WARNING:
Always use supplied guard when depressed
•
center grinding wheel/Multi-disc is on tool. Wheel
can shatter during use and guard helps to reduce
chances of personal injury.
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
In case of mounting a depressed center grinding wheel
/multi-disc thinner than 4 mm, place the lock nut so that
the protrusion on the lock nut faces outside. Otherwise,
place it so that the protrusion on it fits into the inner
diameter of the wheel/disc.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
013087
To remove the wheel, follow the installation procedure in
reverse.
WARNING:
Only actuate the shaft lock when the spindle is not
installation
moving.
OPERATION
WARNING:
It should never be necessary to force the tool. The
•
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while
•
grinding.
7
1. Lock nut
1
2. Depressed
center grinding
2
wheel/Multi-disc
3. Inner flange
3
1. Lock nut wrench
2. Shaft lock
Tabla de contenido
