Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1.
Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 4). Pull back
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of tight connection.
Figure 4 — Connect High Pressure Hose to Spray Gun
NOTE: Remove and discard all pump shipping caps before
attaching hoses.
2.
Similarly, attach other end of high pressure hose to
high pressure outlet on pump. Pull down on collar of
quick connect, slide into pump and let go of collar. Pull
on hose to be sure of tight connection.
3.
Before you connect your garden hose to water inlet,
inspect inlet screen (Figure 5). Clean screen if it
contains debris, replace if damaged. DO NOT RUN
PRESSURE WASHER IF SCREEN IS DAMAGED.
Figure 5 — Connect Garden Hose to Water Inlet
3400 PSI Pressure Washer
4.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
5.
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a 'Y' shut-off connector or other
convenience-type water shut-off valve.
• Damage to equipment resulting from failure to follow this
6.
• Always wear eye protection when using this equipment or in
• Before starting the pressure washer, be sure you are wearing
Checklist Before Starting Engine
Review the unit's assembly to confirm you have performed
all of the following:
1.
2.
3.
Inspect inlet
4.
screen. DO NOT
5.
use if damaged;
clean if dirty.
6.
7.
8.
8
8
Run water through garden hose for 30 seconds to
clean out any debris.Turn off water.
Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 5).
CAUTION
instruction will void warranty.
Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WARNING
High pressure spray can cause paint chips or
other particles to become airborne.
vicinity of where equipment is in use.
adequate eye protection.
Make sure handle is in place and secure.
Make sure shipping cap was removed and oil distick
was installed in pump.
Check that oil has been added to the proper level in
engine crankcase.
Add proper fuel to fuel tank.
Check for properly attached hose connections.
Check to make sure that there are no kinks, cuts, or
damage to high pressure hose.
Provide a proper water supply at an adequate flow.
Be sure to read "Safety Rules" and "How To Use
Pressure Washer" before using the pressure washer.
Capítulos
Tabla de contenido
