Becken BDH4758 Manual De Instrucciones página 33

Removing the collected water
There are two ways to remove
collected water.
1. Use the collector
• When the collector is full, the
Full indicator light will illuminate
and the digital display will show
"P2".
• Slowly pull out the collector.
Grip the left and right handles
securely, and carefully pull
it out straight, so that water
does not spill. Do not place the
collector on the floor because
the bottom of the collector is
uneven. Otherwise, the collector
will fall and spill water.
• Throw away the water and
replace the collector. This must
be in place and securely seated
for the dehumidifier to operate.
• The dehumidifier will resume
its original operation when
the collector is replaced in its
correct position.
NOTES:
• When you remove the collector, do not touch any parts inside of the
unit. Doing so may damage the product.
• Make sure you push the collector gently all the way back into the
unit. Banging the collector against anything or failing to push it in
securely may cause the unit not to operate.
Dehumidifier | Deshumidificador | Desumidificador
1. Slightly pull out the collector.
2. Hold both sides of the collector
with even strength, and pull it
out from the unit.
3. Put the water out
EN
Fig. 5
Fig. 6
33