Bosch Rexroth SE352 Manual De Instrucciones página 22

22/88 Bosch Rexroth AG
B-slot interface (B1) (SE352M)
This interface is intended for use of type B
interface modules from Rexroth.
ATTENTION
Damage due to improper assembly!
Damage to the connections
y Carefully insert the modules following
the assembly instructions in the module
operating instructions.
y Only use interface modules from
Rexroth.
The slot can be equipped with any of the
following modules:
Tab. 1:
Mod- Description
ule
IM24V 24 V inputs/outputs 0 608 830 259
IMser Serial
SE352/SE352M | 3 609 929 B61/2008-09
LED and reset bu tton
There are four LEDs on the front panel of the
control unit, which indicate the operating
conditions of tightening channels 1 and 2.
Fig. 2:
The reset button can be used to reset the
hardware. For further information, please
refer to chapter "9 Maintenance and repair"
Order
on page 26.
number
The assignment of the servo amplifiers to the
0 608 830 260
tightening channels is shown in Fig. 3:
Fig. 3: Tightening channel assignment
Green
1 2
Green, flashing Not ready for opera-
LED
Red, flashing
LED Green
Red, flashing
Button
* Possible causes: Sequence test, nutrunner in bypass
Tightening channel 1
SE LT LT
Tightening channel 2
Ready for operation
tion, but no system
error
System error
Tightening result OK
Tightening result NOK
Reset