General Safety Instructions; Special Safety Instructions For This Device - AEG FR 5554 Instrucciones De Servicio

Freidora de zonas frías
Ocultar thumbs Ver también para FR 5554:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17

General Safety Instructions

Read the operating instructions carefully before putting
the appliance into operation and keep the instructions
including the warranty, the receipt and, if possible, the
box with the internal packing. If you give this device to
other people, please also pass on the operating instruc-
tions.
• The appliance is designed exclusively for private use
and for the envisaged purpose. This appliance is not
fit for commercial use. Do not use it outdoors. Keep it
away from sources of heat, direct sunlight, humidity
(never dip it into any liquid) and sharp edges. Do not
use the appliance with wet hands. If the appliance is
humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the ap-
pliance and always pull out the plug from the socket
(pull the plug itself, not the lead) if the appliance is
not being used and remove the attached accessories.
• Do not operate the machine without supervision.
If you leave the room you should always turn the
device off. Remove the plug from the socket.
• The device and the mains lead have to be checked
regularly for signs of damage. If damage is found the
device must not be used.
• Do not try to repair the appliance on your own.
Always contact an authorized technician. To avoid
the exposure to danger, always have a faulty cable be
replaced only by the manufacturer, by our customer
service or by a qualified person and with a cable of
the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety
Instructions".
Children and Frail Individuals
• In order to ensure your children's safety, please keep
all packaging (plastic bags, boxes, polystyrene etc.)
out of their reach.
WARNING!
Caution! Do not allow small children to play with
the foil as there is a danger of suffocation!
• This device is not intended to be used by individuals
(including children) who have restricted physical,
sensory or mental abilities and/or insufficient knowl-
edge and/or experience, unless they are supervised
by an individual who is responsible for their safety or
have received instructions on how to use the device.
• Children should be supervised at all times in order to
ensure that they do not play with the device.
Symbols in these Instructions for Use
Important information for your safety is specially
marked. It is essential to comply with these instructions
in order to avoid accidents and prevent damage to the
machine:
05-FR 5554 AEG.indd 29
WARNING:
This warns you of dangers to your health and indicates
possible injury risks.
CAUTION:
This refers to possible hazards to the machine or other
objects.
NOTE: This highlights tips and information.
Special Safety Instructions
for this Device
WARNING:
• Never add water to the oil!
• Oils and fats may burn when overheated. Please be
careful! Do not forget to switch the device off after
use! First turn the thermostat to the lowest position
and then remove the mains plug.
CAUTION:
OVERHEATING OF THE HEATING ElEMENT
Please note this important information if you would
like to use fat in the deep fat fryer!
The fat has to be melted slowly so that it can enclose
the heating element.
When fat is placed in the deep fat fryer for the first
time or melted again, there is a danger of overhea-
ting if the selected temperature is too high!
Placing fat in the deep fat fryer for the first time
• Liquefy the fat beforehand in a separate vessel.
WARNING:
Do not heat the fat above 50°C in order to prevent
injury when transferring it from the vessel to the
deep fat fryer.
• Transfer the liquefied fat to the frying fat contai-
ner.
• Once the required oil level has been reached you
can set the desired temperature on the thermostat.
Reheating hardened fat in the deep fat fryer
If the fat in the deep fat fryer has become hard, it
is difficult to know how much it has already melted
down at the heating element.
• Turn the thermostat slowly up until the control
lamp shows that the heating is working.
STOP! Do not turn any further! The heating will
now slowly heat up the fat.
• A short time later the heating switches off again.
• Turn the heating on again by readjusting the ther-
mostat.
• Repeat the process until the fat has melted.
English
29
31.08.11 09:55
Tabla de contenido
loading

Tabla de contenido