Silverline DIY 350W Manual Del Usuario página 10

GB
Storage
• Store this tool carefully in a secure, dry place out of the reach of children. If the tool is
permanently set up in a workshop or garage, ensure access is restricted to prevent children
operating the tool.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
Problem
Drill press will not start
Abnormal or high levels
of operating noise
Drill bit smoking and excessive heat
Drill bit wobble or run out
Drill bit binds in workpiece
10
Possible Cause
Mains connection not correct
Mains plug fuse blown
Pulley Cover (4) not closed
ON/OFF Switch (3) faulty or another tool fault
Incorrect belt tension
Spindle needs lubricating
Worn or damaged pulley drive belt
Loose screws or other fittings
Speed setting incorrect
Blunt drill bit
Material or drill bit should not be drilled dry
Bent drill bit
Drill bit not centrally located in Chuck (7)
Worn spindle bearings or other parts
Pulley belt has incorrect low tension
Solution
Check mains plug is fully inserted in socket and socket is switched on. If RCD is fitted check that it is reset/on
Check fuse in mains plug and replace if necessary with same value
Ensure Pulley Cover is fully closed and securely fastened. If necessary also check the safety switch
mechanism inside the Pulley Cover is not damaged
Contact your Silverline dealer or authorised service centre
Adjust tension (see Adjusting Speed)
See 'Maintenance' . Contact your Silverline dealer or an authorised service centre if necessary
Replace belt. Contact your Silverline dealer or www.toolsparesonline.com for a replacement belt
Check body of tool and inside Pulley Cover to make sure all parts are secure and correctly fitted
Change speed (see Adjusting Speed)
Replace or sharpen drill bit
Use lubricant or cutting fluid
Replace drill bit
Refit drill bit in Chuck
Contact your Silverline dealer or an authorised service centre
Adjust tension (see Adjusting Speed)