Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Customer Responsibilities
Check Safety Valve
Drain Tank
Oil Leaks
Check Oil
Change Oil
Air Filter
1- more frequent in dusty or humid conditions
voltage sources, compressed air, or moving parts. Personal injuries can
occur. Before performing any maintenance or repair, disconnect power
source from the compressor and bleed off all air pressure.
To ensure efficient operation and longer life of the air compressor outfit, a
routine maintenance schedule should be prepared and followed. The following
routine maintenance schedule is geared to an outfit in a normal working
environment operating on a daily basis. If necessary, the schedule should be
modified to suit the conditions under which your compressor is used. The
modifications will depend upon the hours of operation and the working
environment. Compressor outfits in an extremely dirty and/or hostile
environment will require a greater frequency of all maintenance checks.
NOTE: See "Operation" section for the location of controls.
To Check Safety Valve
an explosion.
1.
Before starting compressor, pull the ring on the safety valve to make sure
that the safety valve operates freely. If the valve is stuck or does not
operate smoothly, it must be replaced with the same type of valve.
To Drain Tank
1.
Set the On/Auto/Off lever to "OFF".
2.
Pull the regulator knob out and turn clockwise to set the outlet pressure to
zero.
3.
Remove the air tool or accessory.
4.
Pull ring on safety valve allowing air to bleed from the tank until tank
pressure is approximately 20 psi. Release safety valve ring.
MAINTENANCE
Before
each
use
G
Unit cycles automatically when power is on. When
performing maintenance, you may be exposed to
If the safety valve does not work properly, over-
pressurization may occur, causing air tank rupture or
15- ENG
Daily or
Every
Every
after
8
40
each
hours
hours
use
G
G
G
G
1
Every
Every
160
100
Yearly
hours
hours
G
D24064
Tabla de contenido
