THERMEx ASTON Instrucciones De Uso página 69

B 527230061210122015
• The indicator will now flash with the number 0.
• Use the (+)- and (-)-symbols to adjust the time that the after-run function shall run. If '1'
is selected, the after-run will run for 10 minutes, if '2' is selected, after-run runs for 20
minutes, etc. The after-run function can be set for a maximum of 90 minutes.
• Confirm the selected time by pressing on the on/off after-run symbol.
• The indicator of speed will now display the speed at which the motor runs at and the
panel indicator will flash to indicate that the after-run function is activated.
The after-run function can be interrupted earlier than requested by pressing the on/off
after-run symbol or by switching off the hood, as described in the section EXTRACTION on
page 68. If the after-run function is interrupted, then the panel indicator will stop flashing.
Should it be desirable to regulate the speed of the after-run function after it has been
activated, then this is done using the (+)- and (-)-symbols until the desired speed has been
reached. The panel indicator will continue to flash to indicate that the after-run function is
activated.
RECIRCULATION
The hood can be used for recirculation. This is used in kitchens and locations where there is no
possibility of venting into open-air. The air is sucked first through the grease filter and then
through a filter with activated carbon which removes odours.
NOTE: Two recirculation filters must be used, and these are not included in the purchase of the
hood, although they can be bought as accessories. The product number on a set of recircula-
tion filters is 535.23.0550.9.
The recirculation filters are installed on the motor inside the hood.
The recirculation filters are installed as follows:
THERMEX ASTON 69