Oster TF1600 Manual De Instrucciones página 4

INSTRUCTIONS FOR USE
BEFORE USING FOR THE FIRST TIME
Read and follow all the instructions for this section on use and care and find a place to keep
this instruction manual ready for future reference.
For your convenience, record the complete model number (located at the bottom of the
motor) and the date you received the product, together with your purchase receipt and
attach to the warranty and service information. Retain in the event that the warranty service
is required.
NOTE: The use of attachments not recommended or sold by Sunbeam Products, Inc. may
cause fire, electrical shock, injury or damage to the product.
1. Remove the plastic screw from the bottom of the motor assembly (turning counter-
clockwise). Then attach motor assembly to base hole until snapped. Tighten screw to the
base. (see Figure 1).
CAUTION: The thumbscrew must be fully tightened before the fan is operated.
2. Remove the blade retaining nut (turning clockwise) while holding motor shaft. Remove
the guard retaining nut (turning counter-clockwise) while holding motor housing. Take off
the motor shaft sleeve protector and discard.
3. Set the rear guard in the proper position (carry handle up) on the motor assembly. Then
screw on the guard retaining nut (turning clockwise) until tight.
4. Install the blade onto the shaft of the motor assembly and screw on the blade retaining
nut (turning counter-clockwise while holding the blade) until tight.
5. Loosen, but do not remove the guard locking screw/nut. Place the shroud on the rear
guard with the guard locking screw/nut at the bottom. Assemble the front guard into
shroud so that all sides snap. Rotate the front guard until the Oster
6. Secure both guards firmly by fitting and tightening the guard locking screw/nut located at
the two ends of the shroud.
CAUTION: Do not over-tighten.
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS
3
logo is upright.
®