Cleaning And Maintenance; Troubleshooting - Cuisinart CPT-540 Manual De Instrucciones

CLEANING AND MAINTENANCE

1. Always allow the toaster to cool completely before cleaning.
2. Always unplug the toaster from the electrical outlet before
cleaning.
3. Do not use abrasive cleaners. Simply wipe the exterior with a clean,
damp cloth and dry thoroughly.
4. To remove crumbs, slide out the crumb tray and discard crumbs.
Wipe clean and replace. Never operate the toaster without the crumb
tray in place.
5. To remove any pieces of bread remaining in the toaster, unplug the
toaster, turn it upside down and gently shake. Never insert any hard
or sharp instruments into the slots, as this could damage the toaster
and cause a safety hazard.
6. Never wrap the cord around the outside of the toaster. Use the cord
storage cleats on the underside of the toaster.
7. Any other servicing should be performed by an authorized
service representative.

TROUBLESHOOTING

PROBLEM
Why won't my unit turn on?
Why does the bread go up
and down repeatedly and/or
display shows an "E" while
my toaster beeps?
Why do both heaters turn on
when I select Single Slice?
Can I add time during the
toasting cycle?
I can't get my Memory
settings to reset, what
should I do?
7
SOLUTION
Make sure your unit is plugged into a
functional outlet.
If this doesn't solve the issue, call
our Consumer Service Center at
1-800-726-0190.
Your bread may have gotten caught.
This happens most often when the
bread is too thick for the slot. Unplug
the toaster, let it cool down and check
that the bread is not stuck and try
running a toast cycle with no bread.
If the issue persists, call our Consumer
Service Center.
It is normal for both heaters to turn on.
They are internally programmed to
adjust the intensity and time when
Single Slice is selected.
Yes, you can add time to the toasting
cycle by increasing your shade level or
pressing the +30 Secs button.
Try following the steps 1-3 on page 5 of
this instruction booklet.
Make sure you are pressing the BREAD
TYPE and MEMORY buttons while
plugging the unit back in the outlet.