Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Figure 2
Tension Knob
Figure 3
Armrest
9
10
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
Allen Wrench
8
Mechanism
Seat Cushion
Back Support
Seat Cushion
2. Align mechanism with holes on bottom of seat
cushion with tension knob facing the front of seat.
Use four 5/16 x 1" screws (8) to secure. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align armrest with holes on seat cushion and back
support. Use four 5/16 x 1⁄" screws (9) to loosely
secure. Repeat on opposite side. Once all eight
screws are installed, fully tighten. Insert plastic caps
(10) in holes to cover screws. (See Figure 3)
4. Slowly lower chair assembly onto the gas lift. Press
down on seat cushion to secure. (See Figure 4)
0721 IH-4116
Tabla de contenido
