Dometic FTC Instrucciones De Uso página 13

Setting up the extension
!
CAUTION! Risk of injury and
material damage
• Do not use any type of compressor
designed to inflate car tires.
• Only inflate the air poles into the green
zone of the pressure gauge of the
hand pump (10 psi/0.68 bar). Hand
pump is supplied with the main prod-
uct.
A
NOTICE! Material damage
Use graphite to lubricate the zipper
when it is stuck.
I
NOTE
• The extension comes with heavy duty
pegs. These will be suitable for many
sites but for some types of ground
special pegs will be needed. Ask your
dealer.
• Drive the pegs at a 45° angle away
from the canopy into the ground.
• Peg each guy line in-line with the seam
they start from.
Keep the following tips in mind while setting up the
extension:
• The illustrations provide a general overview of
the set-up. The actual set-up will vary slightly
based on the model of extension.
• Get help. The set-up is easier with more people.
• Peg the guy lines so that the extension is under
tension without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Setting up the annexe
I
NOTE
• The annexe can only be fitted to the left
side of the tent.
• When zipping the annexe to the tent
make sure the annexe is not inside out.
➤Proceed as shown: fig. 2, page 4 to fig. 9,
page 6.
Setting up the canopy
For extra security the main product is supplied with
a Storm Tie Down Kit. The front two ties can be
taken from the main product and attached to the
canopy instead.
1. Proceed as shown: fig. 0, page 6 to fig. d,
page 7.
2. Attach the storm straps to the corners of the
canopy.
Setting up the vestibule
➤Proceed as shown: fig. e, page 8 to fig. i,
page 9.
Dismantling the extension
A
NOTICE! Material damage
Do not use force. Otherwise you might
damage any material.
Keep the following tips in mind while dismantling
the extension:
• The illustrations provide a general overview of
the set-up. The actual set-up will vary slightly
based on the model of extension.
• Remove any dirt on the outside.
• Close all window blinds or remove curtains.
• Close all doors and openings.
• Ensure that all parts are clean before packing the
into the carry bag.
• If the extension is wet or damp, dry fully as soon
as possible.
Dismantling the annexe
1. Remove the groundsheet.
2. Loosen the webbing straps at the base of the
aluminum pole.
3. Remove the plastic clips from the aluminum
pole.
4. Remove all pegs.
5. Unzip the annexe.
6. Fold/roll the annexe to fit in the carry bag.
Dismantling the canopy
1. Remove the groundsheet.
2. Open the valve on the AIR pole and wait until
most of the air has been expelled.
4445103455 13