Fitting The Sandpaper - Black and Decker KA110 Manual De Instrucciones

All manuals and user guides at all-guides.com
ENGLISH
OPERATING YOUR SANDER
To switch your sander
on, slide the on/off
switch forward until
the mark "I" appears.
To switch your sander
off, slide the on/off
switch to the rear until
the mark "O" appears.
Before plugging your sander in, make sure it is
switched off.
SPEED CONTROL (KA110E)
The speed control
switch (2) gives the
best operating
performance for each
material. As a general
rule, use low speed for
polishing and for
sanding acrylic/
synthetic materials, and high speed for wood and metal.
The following table gives an indication of which
settings to use:
Material Variable speed setting
Hardwood (beech) 4-5
Softwood (pine) 4-5
Veneer wood 3-4
Synthetic materials 2-3
Acrylic sheet 1-3
Non-ferrous metals 4-5
Steel 3-4
Lacquer and paint removal 3-5
Polishing 1-2
Rust removal 4-5
REMOVING AND REFITTING THE SANDING PLATEN
Proceed as follows:
Disconnect the plug from the electricity supply.
Turn the platen locking
lever (3) anti-clockwise
(to the left from the
front of your sander)
and lift your sander off
the platen.
To refit the sanding
platen, place the back of the sander into the locating
points on the platen and push the front downwards.
The platen locking lever should now be turned
clockwise (to the right from the front of your sander)
22
into the locked
position.
Note: Make sure that
the lever is fully down
before operating the
sander.
Your sander can be
used in one of two
ways, with the sanding
platen either with the
pointed detail section
at the front of your
sander, or with the
square section at the front of your sander.

FITTING THE SANDPAPER

Your sander uses pre-cut punched nylon backed
sheets of a specific size and shape. To fit the
sandpaper proceed as follows:
Disconnect the plug from the electricity supply.
Detach the two
diamond shaped spare
tips from the main
sheet. Place the
sandpaper on the
pointed base making
sure the holes of the
paper are aligned.
Never use your sander without sandpaper and always
use a full sheet of paper.
Each sheet of
sandpaper has a
removable tip, with two
spare tips attached. To
obtain maximum use
from each sheet,
detach and turn the tip
when the front part is
worn. When the whole tip is worn, replace it with a
new tip which is available as an accessory.
The tip of the backing pad is removable. When the front
part is worn, turn the tip. When the tip is completely
worn, replace the tip.Spare tips are available as
accessories. When the tip of the hard plastic tip holder
is worn, remove the screw and turn the holder. Spare
holders are available as accessories.