3M Nano-Lok Manual Del Usuario página 22

Serial Number(s):
Model Number:
Inspection Date:
Component: Inspection:
SRD Inspect for loose fasteners and bent or damaged parts.
(Figure 18)
Inspect the Housing (A) for distortion, cracks, or other damage.
Inspect the Swivel (B) and Swivel Eye (C) or Integral Connector (D) for
distortion, cracks, or other damage. The Swivel should be attached securely to
the SRL, but should pivot freely. The Swivel Eye or Integral Connector should
rotate freely in the Swivel.
The Web Lifeline (E) should pull out and retract fully without hesitation or
creating a slack line condition.
Ensure the SRD locks up when the Lifeline is jerked sharply. Lockup should be
positive with no slipping.
All labels must be present and fully legible (see Figure 20).
Inspect the entire SRD for signs of corrosion.
End Connectors Table 2 identifies the End Connectors that should be included on your
(Figure 19) Nano-Lok SRD model. Inspect all Snap Hooks, Carabiners, Rebar Hooks,
Interfaces, etc. for signs of damage, corrosion, and proper working condition.
Where present: Gates should open, close, lock, and unlock properly, and
Locking Buttons and Locking Pins should function correctly.
Web Lifeline Inspect webbing; material must be free of cuts (A), frays (B), or broken fibers.
(Figure 20) Check for tears, abrasions, heavy soiling (C), mold, burns (D), or discoloration.
Inspect stitching; Check for pulled or cut stitches. Broken stitches may be an
indication that the harness has been impact loaded and must be removed from
service.
Energy Absorber Verify that the integral Energy Absorber has not been activated. An open cover
(Figure 21) or torn cover (A), webbing pulled out of the cover, torn or frayed webbing (B),
ripped stitching, etc. are indicators of an activated Energy Absorber.
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Table 3 – Inspection and Maintenance Log
(See Section 2 for Inspection Frequency)
22
Date Purchased:
Date of First Use:
Inspected By:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Pass Fail