Positioning Table And Workpiece - RIDGID DP1550 Manual Del Propietário

Positioning Table and Workpiece

Lock the table to the column in a position
so that the tip of the drill is just a little
above the top of the workpiece.
Always place a piece of backup material
(wood, plywood, etc.) on the table under-
neath the workpiece. This will prevent
"splintering" or making a heavy burr on
the underside on the workpiece as the
drill breaks through. To keep the backup
material from spinning out of control, it
must contact the left side of the column,
as illustrated.
WARNING: To prevent the work-
piece or the backup material
from being torn from your hand
while drilling, position them
against the left side of the col-
umn. If the workpiece or the
backup material are not long
enough to reach the column,
clamp them to the table. Failure
to do this could result in per-
sonal injury.
For small pieces that cannot be clamped
to the table, use a drill press vise (not
included).
WARNING: The vise must be
clamped or bolted to the table to
reduce the risk of injury from
spinning work and vise or tool
breakage.
All manuals and user guides at all-guides.com
Drill Press
31
Workpiece
Backup
Material
Workpiece
Vise
Bolt or Clamp Vise Securely