Package Contents; Getting Started - Fontastic X540Ri Manual De Usuario

The on-ear HD Bluetooth headphone X540Ri is your perfect companion to listen to music and for phone calls. Enjoy top audio
®
quality without loss with the aptX
established by simply touching both devices.

Package contents

• Fontastic ® X540Ri
• Micro-USB charging cable
• 3,5mm jack cable
• Multilingual user manual
If any of the above pieces is missing, please pack the product again and return to dealer.
Overview
1. Headband
2. Ear cushions
3. Speaker
4. Micro USB connector
5. Line-in connector
6. NFC unit
7. Multifunction button
8. Previous track button
9. Next track button
10. Microphone
11. LED indicator
12. Volume + button
13. Volume – button
LED functions
Connected Blue fl ashes every 5 seconds
Not connected Blue fl ashes every 5 seconds
Incoming call Blue fl ashes
Exhausted battery Red blinking
Charging Red fl ashes
Pairing Red/Blue fl ashing alternatively

Getting Started

Charging the battery
The Fontastic X540Ri is equipped with an internal rechargeable lithium-polymer battery. Connect the X540Ri with the micro
®
USB cable which is included in the package contents. The cable can be connected to a computer or a standard USB power supply.
The red led of the X540Ri is fl ashing during the charging process. The typical charging time is 2-3 hours. At full charge, the red
LED goes off. The cable can now be disconnected from the Fontastic
red LED.
Note: Charge X540Ri for at least 3-4 hours before initial use.
Switching On /Off
To switch on, press the multifunction button for 3 seconds, the blue LED fl ashes.
To switch off, press the multifunction button for 5 seconds, the red LED fl ashes.
Pairing
The X540Ri must be paired with a Bluetooth
With the NFC feature of the X540Ri pairing can be set-up automatically.
For that purpose Bluetooth and NFC must be enabled on the Smartphone, and the X540Ri must be turned on.
®
To pair or connect via NFC, the Smartphone will be held on the outer right side of the X540Ri. Both devices pair and connect
automatically.
For manual pairing without NFC perform following steps:
1. In the off state, press and hold the multifunction button for 7 seconds to enter pairing mode. The LEDs will fl ash alternately
between blue and red to indicate that it is in pairing mode.
2. Use your Bluetooth enabled device to search for Bluetooth
®
3. The Bluetooth device should indicate that it has found „X540Ri".
®
4. Confi rm pairing with X540Ri. Enter „0000" if you are asked for a pairing code.
If you are unsure about the pairing procedure of your Bluetooth
Bluetooth transmitter without display, set it to pairing mode and wait a few seconds until the connection with X540Ri is
®
established.
codec. The pairing is easier than ever with the built-in NFC function. The connection is
®
1
2
3
4
5
® device before it can be used.
®
®
User Manual
7
8
9
6
10
® X540Ri. A Low Battery condition is indicated by a fl ashing
audio devices.
device, please check your device manual. When using a
GB
11
12
13