DeWalt DCS387 Manual De Instrucciones página 8

• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V
household electrical power. Do not attempt to use ff on any
other voltage. This does not apply to the vehicular charger.
Chargers
Your tool uses a DEWALTcharger. Be sure to read all safety instructions
before using your charger. Consult the chart at the end of this manual
for compatibility of chargers and battery packs.
Charging Procedure (Fig. 1)
1. Plugthechargerintoanappropriate FIG.1
outlet before inserting the battery
pack. F
2. Insert the battery pack (F) into the
charger, as shown in Figure 1,
making sure the pack is fully seated
in charger. The red (charging)light
will blink continuously, indicating
that the charging process has
started.
3. The completion of charge will be
indicated by the red light remaining
ON continuously. The pack is fully
charged and may be used at this
time or left in the charger. DCBI01
Indicator Light Operation
DCBI01
PACK CHARGING
PACK CHARGED
-ZHOT/COLDDELAY --e --e --e --o --e
_t_ PROBLEM P ACK ORCHARGER • • • • • e o e • •
PROBLEMPOWERLINE eo ee ee oe ee
DCBI07, DCB112
i ,!,a "_ PACK CHARGING
_ PACK CHARGED
Charge Indicators
Some chargers are designed to detect certain problems that can
arise. If this occurs, re-insert the battery pack into the charger. If the
problem persists, try a different battery pack to determine if the charger
is working properly. If the new pack charges correctly, then the original
pack is defective and should be returned to a service center or other
collection site for recycling. If the new battery pack elicits the same
trouble indication as the original, have the charger and the battery pack
tested at an authorized service center.
NOTE" On the DCB101, problems are indicated by the red light
flashing at a fast rate.