GE PK916-27" Manual Del Propietário página 29

Problem
You have a function
or letter" flash error code.
in the display
If the function code repeats.
Display goes blank A fuse in your home may
be blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Display flashes Power failure.
Unable to get the Oven control pads were
display to show "SF" not pressed properly.
"PROBE" appears This is reminding you to
in the display enter a probe temperature
after plugging in the probe.
Power outage, Power outage or surge.
clock flashes
Steam from the vent When using the convection
feature, it is normal to see
steam coming out of the
oven vent. As the number
of racks or amount of
food being cooked increases,
the amount of visible steam
will increase.
"Burning" or "oily" This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time.
the vent
Strong odor An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise A cooling fan or a convection • This is normal. The cooling fan will turn on
fan (depending on the
function you are using)
may automatically turn on.
All manuals and user guides at all-guides.com
Possible Causes What To Do
• Press the Clear/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The Bake and Broil Hi/Lo pads (on double oven
models, use the upper oven controls) must be
pressed at the same time and held for 3 seconds.
• Enter a probe temperature.
• Reset the clock. If the oven was in use, you must reset
it by pressing the Clear/Off pad, setting the clock
and resetting any cooking function.
• This is normal.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
to cool internal parts. It may run for up to 1-1/2
hours after the oven is turned off. The convection
fan will cycle on and off until the function is over
or the door is opened.
GEAppliances.com
29