Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USING THE TOOL
Air Source
1. This tool applies to normal air compressor and is designed to operate in clean, dry and
compressed air at regulate pressures between 4 – 8 bar.
2. Place two or three drops of air tool oil il1to the tool's air inlet at the beginning of workday and try it
twice or three times.
HOW TO USE
CAUTION: Check and replace any damaged or worn components in the tool. The safety warning
labels in the tool must also be replaced if they are not legible.
1. Attach a high flow pick connect fitting to the tool.
2. Empty the magazine.
3. Connect the tool to an air compressor using the air hose. Made sure the hose has a rated working
pressure exceeding 200psi and a female quick coupler.
4. Regulate the air pressure to obtain 4 – 8 bar at the tool.
5. Disconnect the air supply from the tool.
6. Load fastener into your tool following the instructions this manual.
7. Reconnect the air supply to the tool.
8. Grip tool firmly and hold trigger while pushing the tool firmly against work surface.
LUBRICATION AND MAINTENANCE
1. Disconnect the air supply from the tool before lubricating.
2. Your tool requires lubrication before you use it for the first time.
3. Wipe off excessive oil at the exhaust. Excessive oil will damage o-rings of tool. If in-line oiler is
used, manual lubricating through the air inlet is not required.
4. Turn the tool so the inlet is facing up hand put one drop of air tool oil. Never us detergent oil or
additives. Operate the tool briefly after adding oil.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
