Russell Hobbs 13704-56 Instrucciones página 3

drawings
1 cover
2 reamer
3 pulp collector
4 juice collector
pressing
17 Sit the motor unit on a stable, level surface.
18 Plug the appliance into the power socket.
19 Put a jug under the spout , to collect the juice.
20 Hold the juice collector steady with one hand, and lower the spout with the other hand.
21 Using one half-fruit at a time, place the cut (flesh) side on top of the reamer and press it down.
22 The reamer will turn, pressing the juice out of the half-fruit.
23 The motor is a simple one, so the reamer won't always turn the same way.
24 Move the fruit around, to ensure that the reamer reaches all of the flesh.
, Take care not to press down on the juice collector, or you'll start the high speed function.
25 When you stop pressing, the motor will stop.
26 Do the same with the rest of your fruit.
27 Don't use the appliance continuously for more than 2 minutes. After 2 minutes use, let it rest
for 2 minutes before carrying on.
28 When the pulp collector gets full:
a) remove the piece of fruit that you were pressing
b) put the cover on top of the appliance
c) press the cover down
d) the pulp collector will turn at high speed, to press any remaining juice out of the pulp
e) stop, hold the juice collector steady with one hand, and raise the spout with the other
hand
f) empty the pulp collector, then go back to point 20, and start again
29 When the jug gets full:
a) stop, hold the juice collector steady with one hand, and raise the spout with the other
hand
b) empty the jug, then go back to point 20, and start again.
finished?
30 When you've finished, unplug the appliance disassemble, clean, reassemble, and store away.
31 Store the appliance away from direct sunlight, and, if possible, from fluorescent light.
wheelie bin symbol
To avoid environmental and health problems due to hazardous substances in
electrical and electronic goods, appliances marked with this symbol mustn't be
disposed of with unsorted municipal waste, but recovered, reused, or recycled.
b closed
5 spout
c open
6 feet
7 drive shaft
3
8 holes
9 spindle
10 motor unit